UPS Trainer Demonstrator

The Trainer would Provides complete set up for the practical and experimental knowledge of a general circuit of On Line UPS Trainer with fault creating facility.

Features:

• Circuit diagram printed on PCB.
• Transformer based power supply.
• Strongly support by systematic operating instructions.
• Enclosed in an attractive ABS plastic/wooden box

Specifications:

• Input Voltage : 180-260 Volts, 50 Hz
• Output Voltage : 230 Volts 1%
• Inverter efficiency : 80% minimum
• Over Load Capacity : 110% for 15 minutes.
• Cooling : Forced air cooling
• Technology : PWM
• Rectifier Type : Constant Voltage and current, controlled with facility to change the battery in float, Boost and Trickle modes with automatic change over between float and Trickle mode.
• Ripple in D.C. : Less than 2%
• Protection : Over Load, Low Voltage, High Voltage and Battery Over Charge, Deep Discharge, Short Circuit.
• Indication : Output, Charger and Battery Operation.
• Isolation : The Output is isolated from the line, Provided with spike, Surge, Noise, RFI, and EMI suppression.
• Fault Creation : Provided on board
• Test Points : Provided on board to observe the waveform and signals
• Cabinet : Enclosed in an attractive ABS plastic / wooden box
• Standard Accessories : Instruction and Experiment Manual